Application Instructions

Small Decals

Step 1.
Make sure surface is at least 50 degrees Fahrenheit.
Clean Surface with isopropyl alcohol and Lint Free Microfiber or Cloth.

Step 2.
Peel transfer paper from backing paper.
Be sure the entire sticker is attached to the transfer sheet.
If necessary, use a credit/ID card to press down and better attach the transfer paper to the vinyl.

Step 3.
Be sure the entire sticker is attached to the transfer sheet.
Apply one side of the transfer tape to surface. Use credit/ID card to help smooth down the decal to the surface.

Step 4.
Beginning in a corner, slowly peel the transfer tape at a 45 degree angle.
If any part of the decal starts to come up with the tape, run over that part of the decal with a credit card and try to peel the tape again.

Large Decals - Center Hinge Method

Step 1. Clean the area
Completely clean and dry the desired application surface.

Step 2. Tape it down
Align the decal where you would like it to be.
Tape it in place using masking tape down the middle of the decal. Typically across the shortest dimension.
Its best to avoid going over letters or lines, but its not always possible.
Step back or remeasure to verify nothing has moved. If needed, lift up the tape to reposition.

Step 3. Remove backing
Fold one half back. Begin pulling the backing paper off the application tape.
Cut or rip the backing paper by the tape hinge.

Step 4. Squeegee half
Holding the exposed half rightly at an angle, begin to squeegee over the application tape.
Start from the middle. Apply pressure and overlap your strokes by a half inch to an inch.

Step 5. Remove the rest of backing and continue to squeegee
Take off the tape hinge, and repeat step 3 and 4.

Step 6. Remove application tape
Starting in a corner, slowly peel the transfer tape at a 45 degree angle.
If you encounter vinyl peeling up, simply squeegee harder over that area.